Specifications - Makita 7104L Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
Width of applicable workpiece
Dimensions (L × W × H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting mortise in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the
operator from electric shock. Use only three-wire
extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the tool's
plug.
Model
Max. hole length (Longitudinal)
Max. hole depth
Chain speed
Net weight
Safety class
equipment and
environmentally compatible
END224-1
Noise
The typical A-weighted noise level determined according
to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
its
The vibration
determined according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENE062-1
method and may be used for comparing one tool
with another.
ENF001-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
7104L
130 mm
155 mm
80 mm - 308 mm
300 m / min
512 mm × 298 mm × 513 mm
17.3 kg
Class I
) : 90 dB(A)
pA
) : 103 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 2.5 m/s
h
2
ENG905-1
ENG900-1
vector sum)
2
or less
ENG901-1