Table of Contents
Advertisement
A->B: Only the object crossing the configured line from the A side to the B side
can be detected.
B->A: Only the object crossing the configured line from the B side to the A side
can be detected.
8. Drag the slider to set the sensitivity value.
Sensitivity: Range [1-100]. It stands for the percentage of the body part of an
acceptable target that goes across the pre-defined line.
Sensitivity = 100 – S
S
stands for the target body part that goes across the pre-defined line. S
1
for the complete target body.
Example: if you set the value as 60, the action can be counted as a line crossing
action only when 40 percent or more body part goes across the line.
Note:
Only certain camera models support Sensitivity function.
9. Repeat the above steps to configure other lines. Up to 4 lines can be set. You can
click the Clear button to clear all pre-defined lines.
10. Click the Arming Schedule to set the arming schedule.
11. Click Linkage Method to select the linkage methods for intrusion detection,
including Notify Surveillance Center, Send Email, Upload to FTP/Memory
Card/NAS, Trigger Recording, Trigger Alarm Output, Flashing Alarm and Audible
Warning.
Note:
Only certain models support Trigger Recording, Trigger Alarm Output,
Flashing Alarm and Audible Warning.
12. Click Save to save the settings.
10.2.4 Configuring Region Entrance Detection
Purpose:
Region entrance detection function detects people, vehicle or other objects that enter
a pre-defined virtual region from the outside place, and some certain actions can be
taken when the alarm is triggered.
Network Camera User Manual
/S
*100
1
T
127
stands
T
Advertisement
Table of Contents
