Parts Description - Makita MW001G Instruction Manual

14. If the appliance is not used for a long period
of time, the battery must be removed from the
appliance.
15. During and after use, the battery cartridge may
take on heat which can cause burns or low
temperature burns. Pay attention to the han-
dling of hot battery cartridges.
16. Do not touch the terminal of the appliance
immediately after use as it may get hot enough
to cause burns.
17. Do not allow chips, dust, or soil stuck into the
terminals, holes, and grooves of the battery
cartridge. It may result in poor performance or
breakdown of the appliance or battery cartridge.
18. Unless the appliance supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near high-voltage electri-
cal power lines. It may result in a malfunction or
breakdown of the appliance or battery cartridge.
19. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will also
void the Makita warranty for the Makita appliance and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop appliance operation
and charge the battery cartridge when you
notice less appliance power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the appliance or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).

Parts description

4
5
6
7
8
Fig.1
Handle
1.
2. Control panel
Refer to the following description for detail.
3. Cavity
Door
4.
The appliance must be operated with the door
closed.
Oven door mesh
5.
6. USB port cover
7. Filter cover
8. Battery terminal
Control panel
1 2
Fig.2
1. Power switch button
Power selection button
2.
3. Microwave power
4. Operating time / Error code
5. Battery indicator
6. Pause/Stop button
Time adjustment dial
7.
8. Start button
6 ENGLISH
3 4 5 6
1
2
3
7 8