Using A Password - Epson ActionPC 5000 User Manual

If you set the Disk drive boot sequence in SETUP to
C: only (see Chapter 2), the operating system must be on the
hard disk when you reset the computer. If you selected the
other options, the operating system must be either on the hard
disk or on a diskette in drive A. If you do not have a hard disk,
insert the operating system diskette in drive A. If you are using
DOS, you can press Ctrl Alt Del to reset the system.
You can also press the RESET button located on the front right
side of your computer. The screen displays nothing for a
moment and then the computer reloads the operating system.
If resetting the computer does not correct the problem, you
probably need to turn it off and on again. Remove any
diskette(s) from the diskette drive(s). Turn off the computer
and wait 20 seconds. If your operating system is not on the
hard disk drive, insert a bootable diskette (one that contains the
necessary portions of the operating system) in drive A. Then
turn on the computer.

Using a Password

Using SETUP, you can define both a Supervisor level password
and a User level password. You can also specify whether a
password is required when you start the system. This
password can also control who has access to the diskette drives.
If you enabledthe Password on boot option in SETUP,
you must enter the Supervisor or User password every time
you turn on or reset the computer. If you enter a password but
disable the Password on boot option, you must enter the
password when you start SETUP.
3-6 Using Your Computer