NETGEAR WNR2000 Setup Manual page 8

You can use the status lights to verify various conditions.
Table 1. Status Light Descriptions
Label LED Activity
Solid Amber
Solid Green
Fast blink–Green
1. Power
Slow blink–Green
Off
Solid Amber
Solid Green
2. Internet
Blinking Green
Off
Solid Blue
Blinking Blue
3. Wireless
Off
Solid Green
Blinking Green
4. LAN
Solid Amber
(Ports 1–4)
Blinking Amber
Off
Solid Green
5. Push 'N'
Blinking Green
Connect
Off
4
Description
The router is performing the power-on self-test diagnostic.
The power is on and the router is ready.
A software update is in progress.
There is a problem with the wireless router software.
Power is not being supplied to the router
No IP address acquired.
The wireless router has acquired an Internet address.
Data is being communicated with the Internet.
No Ethernet cable is connected to the modem.
The wireless interface is enabled.
Data is being communicated over the wireless network.
The wireless interface is turned off.
The local port is connected to a 100 Mbps device.
Data is being transmitted at 100 Mbps.
The local port is connected to a 10 Mbps device.
Data is being transmitted at 10 Mbps.
No link is detected on this port.
Indicates a (WPS) connection to a WPS-capable device.
WPA-capable device can associate with the router within 2 minutes.
No WPS connection exists.
Table 1 describes each light.
Getting to Know Your Wireless Router