NETGEAR MR314 Reference Manual page 79

Select binary (not ascii) transfer mode.
3.
Use your FTP program to get (back up) or put (restore) the file named
4.
After you have sent a configuration file to the router, the router programs the new configuration
into flash memory and reboots itself, dropping the FTP session.
If you wish to load new software or transfer the configuration file over the WAN, you must know
the WAN IP address of the router. You must also use the PORTS menu to forward incoming FTP
(port 21) traffic to the router's LAN IP address, usually 192.168.0.1.
This section explains how to restore the factory default configuration settings, changing the
Manager password to 1234 and the IP address to 192.168.0.1. You can erase the current
configuration and restore factory defaults in two ways:
• Use the Erase function of the Web Manager (see
• Use the Default Reset button on the rear panel of the router. Use this method for cases when
the Manager password or IP address is not known.
To restore the factory default configuration settings without knowing the Manager password or IP
address, you must use the Default Reset button on the rear panel of the router.
Press the Default Reset button for 10 seconds, then release it.
1.
If the TEST LED begins to blink, the defaults have been restored and the router is now
rebooting. Otherwise, go to step 2.
Disconnect the power from the router.
2.
While depressing the Default Reset button, reconnect power to the router.
3.
Continue to hold the Default Reset button. The TEST LED will begin to blink, then will
flicker very quickly after about 10 or 15 seconds. This indicates that the defaults have been
restored and the router is now rebooting.
Release the Default Reset button and wait for the router to reboot.
4.
"Erase the Configuration" on page
in the router.
6-5).