NETGEAR MR314 Reference Manual page 35

After your PC is configured and has rebooted, you can check the TCP/IP configuration using the
Windows 95, 98, and Millenium utility
To check your PC's TCP/IP configuration:
On the Windows taskbar, click the Start button, and then click Run.
1.
The Run window opens.
Type , and then click OK.
2.
The IP Configuration window opens, which lists (among other things), your IP address, subnet
mask, and default gateway.
Select your network adapter.
3.
The window is updated to show your settings, which should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
• The IP address is between 192.168.0.2 and 192.168.0.31
• The subnet mask is 255.255.255.0
• The default gateway is 192.168.0.1
Beginning with Macintosh Operating System 7, TCP/IP is already installed on the Macintosh. On
each networked Macintosh, you will need to configure TCP/IP to use DHCP by following these
steps:
From the Apple menu, select Control Panels, then TCP/IP.
1.
(for Windows NT systems, use ).