Verifying Tcp/Ip Properties; Configuring Windows Nt Or 2000 For Ip Networking; Install Or Verify Windows Networking Components - NETGEAR FR114P Reference Manual

Reference Manual for the Model FR114P, FR114W and FM114P Cable/DSL ProSafe Firewall
Select "I want to set up my Internet connection manually" or "I want to connect through a
3.
Local Area Network" and click Next.
Select "I want to connect through a Local Area Network" and click Next.
4.
Uncheck all boxes in the LAN Internet Configuration screen and click Next.
5.
Proceed to the end of the Wizard.
6.

Verifying TCP/IP Properties

After your PC is configured and has rebooted, you can check the TCP/IP configuration using the
utility winipcfg.exe:
On the Windows taskbar, click the Start button, and then click Run.
1.
Type , and then click OK.
2.
winipcfg
The IP Configuration window opens, which lists (among other things), your IP address, subnet
mask, and default gateway.
From the drop-down box, select your Ethernet adapter.
3.
The window is updated to show your settings, which should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
• The IP address is between 192.168.0.2 and 192.168.0.254
• The subnet mask is 255.255.255.0
• The default gateway is 192.168.0.1

Configuring Windows NT or 2000 for IP Networking

As part of the PC preparation process, you need to manually install and configure TCP/IP on each
networked PC. Before starting, locate your Windows CD; you may need to insert it during the
TCP/IP installation process.

Install or Verify Windows Networking Components

To install or verify the necessary components for IP networking:
On the Windows taskbar, click the Start button, point to Settings, and then click Control Panel.
1.
Double-click the Network and Dialup Connections icon.
2.
Preparing Your Network 3-5