Honeywell BW Solo - Portable Single Gas Detector Quick Reference Guide
Overview
- Display
- LED visible alarm ring
- Light sensor
- Control button
- Non-compliance
- Filter reference window
- Gas inlet
- Audible alarm beeper
- Sensor type
- Clip
- IR communication port
- Battery compartment
- For safety reasons, this equipment must be operated and serviced by qualified personnel only.
- Read and understand the instruction manual completely before operating or servicing.
- Substitution of components may impact safety.
- Lithium battery: Only use approved battery: 2/3AA 3.6V 1.65Ah Lithium battery (P/N: 500-0160-000).
- To reduce the risk of electric shock, turn the power off before opening this instrument or performing service.
- Never operate the instrument when the instrument is open.
- Service this product only in an area known to be non-hazardous.
- Recycling: this instrument contains a lithium battery. Do not mix with the solid waste stream. Spent batteries should be disposed of by a qualified recycler or hazardous materials handler.
- This device complies with Part 15 of the FCC Rules / Industry Canada licenseexempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Common device's operations
Power On |
5-second hold |
Power Off |
5-second hold |
Enter Menus |
Double-click |
Select Next |
Single-click |
Initiate Selected |
Long Hold |
Read the User Guide for complete information on the BW Solo operation.
Bump Test/Configuration
- Press twice repeteadily
- Select Bump Test or Configuration, and then follow On-screen instructions until ''Apply Gas?" is displayed.
- Place the calibration cap over the Honeywell BW Solo, and then hook the cap's left clip to the corresponding groove of the detector.
- Press down on the tab to snap the right clip into place.
- Attach hose and open the cylinder valve by turning the pressure regulator knob counterclockwise.
- Remove the calibration cap by pulling on the tab.
Europe, Middle East, Africa
Life Safety Distribution GmbH
Toll-Free 00800 333 222 44
Middle East +971 4 450 5800
Middle East +971 4 450 5852
(Portable Gas Detection)
gasdetection@honeywell.com
Americas
Honeywell Analytics Distribution Inc.
Tel: +1 847 955 8200
Toll free: +1 800 538 0363 detectgas@honeywell.com
RAE Systems by Honeywell
Phone: 408.952.8200
Toll Free: 1.888.723.4800
Asia Pacific
Honeywell Analytics Asia Pacific
Tel: +82 (0) 2 6909 0300
India Tel: +91 124 4752700
analytics.ap@honeywell.com
Technical Services
EMEA: HAexpert@honeywell.com
US: ha.us.service@honeywell.com
AP: ha.ap.service@honeywell.com
www.honeywellanalytics.com www.raesystems.com
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Honeywell BW Solo - Portable Single Gas Detector Quick Reference Guide
Need Assistance?
Do you have a question about the BW Solo that isn't answered in the manual? Leave your question here.