Advertisement
A
djustment
1. Split blade adjusting:Make a straight line with Saw. Adjust a gap with outer circle of Saw
2. Angle stopper adjusting:Adjust at 45 and 90 degrees on the basis of Table.
3. Scale arrow adjusting:Loosen the attaching screw for Arrow, and adjust it to the scale.
4. Parallel ruler adjusting:Adjust so that it may be parallel with Saw and be right angle with the rail of Table.
5. Knob 45 adjusting:Adjust it when it does not move up-and-down smoothly or turns by vibration.
D
isassembly
[ Separation of Gear housing cover from Motor part w/ Gear Housing ]
(1) Remove Saw blade, Inner flange 55 and Outer flange 55.
(2)Turn Knob 45 left, lower Motor part to the lowest limit, and reverse the main body.
(3) Remove Gear housing cover, Blade cover and Screws M5x25.
(4) Gear housing cover and Motor part w/ Gear Housing come apart to both sides from Frame separately.
Hex. Nut
Outer flange 55
Saw blade
[ Disassembly of Gear 45 and Spindle]
Remove Retaining ring S20 and Ball bearing 6204LLB from the above mentioned Gear housing cover ( 4 ).
[ Disassembly of Armature and Field]
Do it by separating Gear housing ( above mentioned ) from Motor part.
[ Disassembly of Lever 80]
(1) Loosen the fastening Front plate of Lever 80
(2) Put Spanner 17 on Hex. Nut M10-6 ( which is farther from Lever 80), put Hex. rod wrench 6 on Hex. Socket head
bolt . Turn Spanner 17 left and Wrench right, and loosen Nut M10-6.
(3) Then, turn Wrench right , gripping Lever 80, pick out Hex. Socket bolt , and remove Lever 80.
Flat washer 40
Inner flange
Blade
covert
Pan head
Gear housing cover
screw M5x25
Frame
Motor housing
Gear housing
Table
Advertisement
