Fig.12
► 1 . Steel ball 2. Grooves on the joint
3.
Install the sleeve.
4.
Install the anvil holder with a wrench while hold-
ing the nose adapter with another wrench. Be sure to
tighten the anvil holder firmly.
5.
Install the lock nut with a wrench while holding
the anvil holder with another wrench. Be sure to tighten
the lock nut firmly.
Installing side grip
CAUTION:
After installing or adjusting the
side grip, make sure that the side grip is firmly
secured.
NOTICE:
Do not install the side grip to any other
area than the designated mounting area.
1
2
1
2
Fig.13
► 1 . Mounting area
The side grip can be swung, allowing easy handling of
the tool in any position. Loosen the side grip by turning
it counterclockwise, swing it to the desired position and
then tighten it by turning clockwise.
Fig.14
► 1 . Side grip
Installing Eyebolts
Eyebolts can be attached on both side of the tool.
Fig.15
► 1 . Eyebolt
9 ENGLISH
1
1
1
1