Table of Contents
Advertisement
2
1
Fig.7
► 1 . Lock nut 2. Anvil holder
2.
Remove the anvil holder with a wrench while
holding the nose adapter with another wrench.
1
Fig.8
► 1 . Anvil holder 2. Nose adapter
3.
Remove the sleeve by sliding it in the direction of
the arrow as shown in the figure.
1
Fig.9
► 1 . Sleeve
4.
Loosen the puller while holding the nose adapter.
Fig.10
► 1 . Puller 2. Nose adapter
Installing the pulling unit (nose
assembly)
1.
Once install the puller all the way until it contacts
the surface of the joint.
2
Fig.11
► 1 . Puller 2. Surface of the joint
2.
Slightly loosen the puller so that the steel ball fits
in one of the grooves on the joint.
If the steel ball is not seated correctly in the groove, the
sleeve cannot be installed in the correct position.
8 ENGLISH
1
2
1
2
Advertisement
Table of Contents
