Table of Contents
Advertisement
NOTICE:
If the operation stops halfway due to
the protection system, pull the switch trigger
again. The puller in the middle returns to the original
position regardless of the specified force. Hold on
the switch trigger until the puller returns to the
original position, and then you can restart the
operation.
If the puller does not return even if you pull the
switch trigger again, the display of control panel
blinks for a few seconds. Ask your local Makita
Service Center for support.
Installing a blind rivet or lockbolt
(with breaking off a mandrel)
For model BV13-177
CAUTION:
Before the mandrel container
becomes full, empty it regularly by removing the
mandrel container. Otherwise, the tool may be dam-
aged, and the damaged parts may cause an injury.
CAUTION:
When inserting a blind rivet or
lockbolt into the nose piece, be sure to switch
off the tool. Otherwise, you may be injured with the
tool tip.
CAUTION:
Be careful not to drop the broken
off mandrel from high locations. Doing so may
cause an accident or injury.
1.
Insert the blind rivet or lockbolt into the nose
piece.
2
1
Fig.18
► 1 . Blind rivet or lockbolt 2. Nose piece
2.
Press the tool tip against the workpiece, and then
pull the switch trigger.
Fig.19
3.
After the mandrel is broken off, release the switch
trigger. The nose piece returns to the original position
automatically.
NOTE: If you release the switch trigger during oper-
ation, the nose piece returns the original position
automatically.
NOTE: If the specified force is less than the breaking
force, the tool stops before breaking off the mandrel,
then the nose piece returns the original position
automatically.
NOTICE:
Tilt the tool back so that the broken
off mandrel falls into the mandrel container after
each operation. Otherwise, the broken off mandrels
may get stuck in the tool.
NOTICE:
If the operation stops halfway due to
the protection system, pull the switch trigger
again. The nose piece in the middle returns to the
original position regardless of the specified force.
Hold on the switch trigger until the nose piece
returns to the original position, and then you can
restart the operation.
If the nose piece does not return even if you pull
the switch trigger again, the display of control
panel blinks for a few seconds. Ask your local
Makita Service Center for support.
Emptying the mandrel container
For model BV13-177
NOTICE:
Be sure to install the mandrel container
to the tool before operating the tool. If the mandrel
container is not installed to the tool, the tool will not
operate.
Remove the mandrel container from the tool when you
empty the mandrel container.
To remove the mandrel container, rotate it
counterclockwise.
To install the mandrel container, follow the removal
procedure in reverse.
Fig.20
► 1 . Mandrel container
NOTICE:
For model BV17-177
Do not remove the rear cap from the tool. No need
to remove the rear cap. If the rear cap is not installed
to the tool, the tool will not operate.
11 ENGLISH
1
Advertisement
Table of Contents
