Voltage Warning - Makita 5012B Instruction Manual

(1) Grip saw firmly. Hold the chain saw firmly w i t h both hands when the
motor is running. Use a firm grip w i t h thumbs and fingers encircling the
chain saw handles.
(2)
Do not over reach.
(3)
Keep proper footing and balance at all times.
(4)
Don't let the nose of the guide bar contact a log, branch, ground, or other
( 5 ) Don't cut above shoulder height.
( 6 )
Use devices such as low kickback chain and special guide bars that
(7)
Only use replacement bars and chains specified by the manufacturer.
Connect chain saw t o correct voltage, that is, be sure that the voltage
supplied is the same as that specified on the nameplate of the tool.
When servicing use only identical replacement parts.
obstruction.
reduce the risks associated w i t h kickback.
17.
Power Supply
18.
Replacement Parts
19.
Wear ear protectors during operation.
20. Before making a felling cut, remove dirt, stones, loose bark, nails, staples
21.
Secure the log so that it will not roll or move suddenly during operation.
22.
AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
23.
Attention! Do not expose this tool t o rain and pull plug immediately if the
24.
The chain saw must not be left outdoors during rain and it must not be used
and wire from the tree.
on switch. Be sure switch is
OFF
when plugging in.
supply cable be damaged or cut.
when wet.
VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool.
A
power source w i t h voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user
-
as well as damage t o
the tool.
If in
doubt, DO NOT PLUG IN THE TOOL. Using a power source w i t h
voltage less than the nameplate rating is harmful t o the motor.
4