Honeywell CN80 Series User Manual page 105

3. Tap Advanced Configs
4. Tap File directory.
5. Specify where on the server device the .xml files to be downloaded are located.
6. Tap NEXT
7. Choose the files to be applied. Tap NEXT.
8. Review the files you have selected. If you need to change any files, tap the Back
9. Proceed to
Set Up Client Devices
The Wi-Fi Staging client runs automatically on the initial boot of a new device.
However, it must be started manually on existing devices.
New Devices
This section applies to new, out-of-the-box devices only. For existing devices, see
the next section.
1. Set up a server device, see
2. Place the new devices to be configured within 1 meter 93 feet) of the server
Note: Client devices should be kept on the Android Welcome or setup wizard screen during
staging. If you finish the setup wizard manually, the client side of the W-Fi Staging will
stop running.
Configurations will be distributed to any client that connects to the server device.
Once the data transmission finishes successfully, the name and serial number of
the configured client will display in the Wi-Fi Staging app on the server device, and
the client device will skip the Android setup wizard.
Existing Devices
To start the Wi-Fi Staging client on an existing device:
1. Set up a server device, see
2. Turn on the client device and launch the Wi-Fi Staging app by tapping Settings
3. Tap To be Staged.
CN80 Mobile Computer Series User Guide
button. Otherwise, tap Confirmed, start staging now! to begin.
Wi-Fi Staging will start a hotspot in the server device and wait for clients to
connect.
Set Up Client Devices
device and turn them On.
When a new device boots up and begins the setup wizard, it will attempt to
retrieve configuration from the server device, and a staging progress screen will
display.
> Honeywell Settings > Wi-Fi Staging.
on page 95.
page 92.
page 92.
95