Installing the Hardware
In order to manage a single hub or stack of StackPro II Dual-
Speed hubs, you should insert one SNMP module into one of
the hubs in the stack. Only one SNMP module is needed to
manage each stack of up to 6 hubs.
Follow these instructions to install the SNMP module in a
StackPro II 10/100 hub or a stack of StackPro II 10/100 hubs.
Please read through all of the provided instructions before
continuing with the installation:
1. Turn off the StackPro II hub. If your hub is connected to a
rack, remove it from the rack. Remove the panel on the back
of the unit marked SNMP. For your safety, it is important to do
this in a safe working environment free of excessive clutter,
electromagnetic interference, and dormant static electricity.
2. Carefully insert the SNMP module (with the circuits and
chips facing up). Gently but firmly slide the module into the
slot and push on it until you feel that the module is securely
connected to the slots inside of the hub. The module should be
firmly set - if you can move it by wiggling it, then it is not
properly connected.
3. Find a PC with a free serial port to use as a "terminal". You
will use this computer to configure your SNMP module. Bring
the computer close to the hub and boot it up.
6