Using the Command Line
Interface
The command line interface can be accessed through the ter-
minal port on the back of the SNMP module or through a tel-
net connection from any computer on the network.
You must configure at least the IP address of the unit using
the command line interface before accessing it through the
web interface.
Before entering the command line interface, the hub will run
several diagnostic tests and it will prompt you to enter a pass-
word. Enter the manager's password. The default password for
the manager access level is "manager". It will remain "manag-
er" until you change it.
The main menu for the command line interface looks like this
Network Management Module Setup
--------------------------------------------
[1] System Settings
[2] Protocol Configuration
[4] Restart Management Kit
[5] SNMP Configuration
[7] Port Management
[8] Firmware Update
[9] Modify Password
[S] Save Current Settings
[R] Restore Default Values
[S] Save Current Settings
[R] Restore Default Values
[X] Exit
Main Menu
10