Removing And Replacing The Ice Cube Storage Case; Water Filter Change Icon; Important User Information - Baumatic TITAN2 Instruction Manual

Removing and replacing the ice cube storage case

o If the storage case does not fully slide back into position, remove

Water filter change icon

o Six months after you connect your appliance to the mains supply
o After changing the water filter (see page 40 for details), press
o If you change the water filter before the FILTER CHANGE icon

Important user information

Get user manuals: See SafeManuals.com
it from the freezer again. Rotate the coil inside of the case a
quarter of a turn and then slide the storage case back into place.
for the first time, the FILTER CHANGE icon will come on.
and hold the RESET WATER FILTER button until the FILTER
CHANGE icon switches off.
comes on, then you should still press and hold the RESET
WATER FILTER button for 5 seconds.
IMPORTANT: Care should be taken to make sure that
the airflow duct vents on the rear interior wall of the
fridge and freezer sections are not blocked.
IMPORTANT: If your mains power supply fails, then
the food inside of the freezer section will be
preserved for a 12 hour period. After 12 hours the
food should be removed from the freezer section and
consumed as quickly as possible.
IMPORTANT: If power is cut to the appliance, when
power is restored it will take approximately 30
minutes for the compressor to start running again.
o Pull the storage case forwards to
remove it from the freezer.
o To put the storage case back into
position, locate it into the side grooves
of the cabinet and push it back into
place.
22