Baumatic TITAN2 Instruction Manual page 37

o Clip the water filter into the filter holder.
5) Remove the cover at the bottom rear of the appliance.
o Insert the fastening ring into the water inlet, you must ensure
o Insert the water inlet into the top of the water valve (the valve is
o After checking that there are no bends in the water inlet, turn on
IMPORTANT- If there are any signs of water leaks, you should follow
the installation procedure stage by stage again.
Get user manuals: See SafeManuals.com
that you follow the direction of the nut.
located to the right of the compressors), then turn the nut
clockwise to securely fasten it.
the water tap and then check thoroughly for any leaks.
4) Screw and fasten the filter
holder to the left or right hand
side of the rear of the appliance.
o If the filter holder does not
attach very well, then
remove the paper that
covers a sticky pad on the
rear of the filter holder and
then screw it into position
again.
37