Restoring Factory Defaults; Initializing From Settings - Buffalo LinkStation 420DS User Manual

3
Connect the UPS and LinkStation using a USB cable or serial cable.
4
Turn on the UPS, then the LinkStation.
5
In Advanced Settings, click Management.
6
Click to the right of "UPS Sync".
7
Click Edit.
8
Configure the desired settings, then click OK.
Notes:
• If the LinkStation is connected directly to a UPS, select "Sync with UPS connected to this LinkStation". If a
different LinkStation is connected to the UPS, select "Sync with UPS connected to another LinkStation on the
same network". After making this selection, enter the IP address of the LinkStation that will be the sync source
in "Other LinkStation's IP Address".
• When the LinkStation is rebooted after an automatic shutdown due to a power outage or other power supply
problem, verify that the power supply has been restored. If the LinkStation is turned on while it is still running
on the UPS and without the power supply restored, automatic shutdown is not performed, even after the
specified time has elapsed.
• If the power supply from the UPS to the LinkStation is stopped and restarted when UPS recovery is enabled,
the LinkStation is automatically restarted.

Restoring Factory Defaults

To initialize the LinkStation to its factory default settings, follow this procedure.

Initializing from Settings

1
In Advanced Settings, click Management.
2
Click to the right of "Restore/Erase".
59