Advertisement
INSTALLATI
NOTES:
This Kit contains more parts than will be used on any
installation. Discard unused parts.
2. Do not remove the antikink springs from the cut tubing.
3. If the pneumatic tubing is surface run, cut away a
portion of the decorative wall ring and spacer ring.
Fig. 2).
95-7135
stat replacement and figure number cross-reference. (continued)
Powers HS & D
Powers T21
mullion application does not require the
odernization K i t .
4. When replacing a one-pipe device, the restrictor must
be replaced with Restrictor 14002913-001 (Fig. 3).
5. The same general installation procedure applies for
all conversions.
2
Advertisement
