Advertisement
Humidistat/Thermostat Cover Mounting
Remove the caution card from the cover.
Select the correct window (vertical or horizontal/dual or
blank) and peel the release liner from window back.
UTION
Before installing the window, carefully check the
window selection and orientation. Once assembled,
disassembly may damage the window.
Ensure that the window is oriented correctly for the
installation. When viewed from the front of the cover,
the setpoint and day/auto openings are on the bottom
for a vertical Thermostat or on the right for a horizontal
Thermostat. The cover has slots which must mate with
the mounting tabs on the backplate.
a.
Insert the top edge of the window into the slot in
the top of the window hole (Fig. 21).
b.
Bend the window slightly and pop the bottom
edge into the slot in the bottom of the
window hole.
Press in place to secure window.
the cover by hooking the two slots on the cover
bottom (right end for horizontal mounting) to the tabs on
the backplate (Fig. 22). Swing the cover into place. Back
out (counterclockwise) the setscrews with the
Thermostat Tool to secure the cover.
Fig. 21. Assembly of cover with wndow and insert.
14002573-001 HP970 HUMIDISTATAND TP970 THERMOSTAT MODERNIZATION KIT
HOLES (4)
CLOSEST
L)
WINDOW
(DUAL SHOWN,
PARTIALLY
INSTALLED)
SE1
Fig. 22. Mounting cover.
15
STAT
BACKPLATE
95-7135
Advertisement
