Cisco Firepower 4100 Series Manual page 19

Overview
7
40-Gb Network Module with Hardware Bypass
The following figure shows the front panel of the 40-Gb hardware bypass network module
(FPR4K-NM-2X40G-F). The FPR4K-NM-2X40G-F is a single-wide module that does not support hot
swapping. The two ports are numbered left to right. Pair the two ports to create a hardware bypass paired set.
Note
Figure 13: FPR4K-NM-2X40G-F
1
3
Network activity LEDs
• Left LED—Green indicates network activity
when a 10M/100M/1G connection is made.
• Right LED—Not in use at this time.
Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade
FXOS Compatibility for the software compatibility matrix.
Captive screw/handle
Port 2 Ethernet X/2
Ports 1 and 2 are paired together to form a
hardware bypass pair.
40-Gb Network Module with Hardware Bypass
—
Guide. See
2 Port 1 Ethernet X/1
Ports 1 and 2 are paired together to form a
hardware bypass pair.
Port 1 network activity LEDs:
4
• Amber—No connection, or port is not in use,
or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
Cisco Firepower 4100/9300
Overview
19