Dc Jack Cover; Disassembling/ Assembling Of Dc Jack Cover; Housing Section; Disassembling/ Assembling Of Battery Terminal - Makita SK105D Repair Manual

5-2

DC Jack cover

5-2-1

Disassembling/ Assembling of DC Jack cover

5-3

Housing section

5-3-1

Disassembling/ Assembling of Battery terminal

Fig. 4
Fig. 5
Fig. 6
1
Pull out DC Jack cover in direction of arrow.
DC Jack cover is not glued with adhesive, and
therefore, remove it manually.
2
Insert DC Jack cover into the groove of Housing
when assembling.
1
Remove 2x8 Tapping screws (2 pcs) with T6
screwdriver.
2
Tighten them with a torque of 0.3 N∙m when
assembling.
3
Battery terminal is assembled with two hooks at the
bottom, and therefore, pull up in direction of (1)
then pull out in the direction of (2). Be careful not
to cut off Lead wires (3 pcs) of the power source
because they have to be connected to Main unit.
5 / 7
Note