Honeywell Farenhyt Series Installation And Maintenance Instructions page 4

FIGURE 8. EXAMPLE OF MULTIPLE BOARDS SHARING SAME EXTERNAL SUPPLY
Refer to figures 8 and 9 for typical wiring. Make certain lip on long power supply jumper engages retaining tab on T5 or T6 as shown in View A-A.
VIEW A-A
ó + ó + ó + ó +
IN OUT
SLC
EXTERNAL SUPPLY
T6 T5
Before installing this product ensure that the tamper seal on the packaging is present and unbroken and the product has not been tampered with since leaving the factory.
Do not install this product if there are any indications of tampering. If there are any signs of tampering the product should be returned to the point of purchase.
It is the responsibility of the system owner to ensure that all system components, i.e. devices, panels, wiring etc., are adequately protected to avoid tampering of the system
that could result in information disclosure, spoofing, and integrity violation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Farenhyt™ is a trademark of and System Sensor ® and Honeywell
PCB 2
ó + ó
ó + ó + ó + ó +
+0 +1 +2 +3 +4 +5
IDC ADDRESS IDC ADDRESS IDC ADDRESS
DEVICE AND SYSTEM SECURITY
FCC STATEMENT
® are registered trademarks of Honeywell International, Inc.
EXTERNAL
POWER
SUPPLY
ó +
+
ó + ó + ó + ó
IN OUT
SLC
EXTERNAL SUPPLY
T6
4
PCB 1
+ ó + ó + ó + ó +
+0 +1 +2 +3
IDC ADDRESS IDC ADDRESS
T5
©2022 Honeywell. 7/1/2022
ó + ó +
+4 +5
IDC ADDRESS
C0142-01
I56-2733-010