Drive Chain Housing - Yamaha FX Nytro FX10A Owner's Manual

Periodic maintenance and adjustment
10. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
1. Secondary sliding sheave
2. Secondary fixed sheave
11. Install the V-belt between the secondary
sliding and fixed sheaves.
1. V-belt
12. Install the drive guard, and then install the
left side cover and the shroud.
ESU12834

Drive chain housing

To check the drive chain housing oil
level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the shroud and the right side
cover. (See page 50 for removal proce-
dures.)
3. Remove the dipstick, wipe it off with a
clean rag, and then screw it back into the
filler hole.
66
1. Dipstick
4. Remove the dipstick and check that the
oil level is within the range shown at the
bottom of the dipstick. If the oil does not
reach the bottom of the dipstick, add suf-
ficient oil of the recommended type to
raise it to the correct level. NOTICE:
Make sure that no foreign material en-
ters the drive chain housing.
1. Oil level range
Recommended drive chain oil:
SAE 75W or 80W API GL-3 Gear oil
[ECS00531]
1