Supported Power Cords And Plugs; Power Cords - Cisco MDS 9100 Series Installation Manual

Supported Power Cords and Plugs

Table C-4
cable.
Table C-4
Pin
1
2
3
6
4
5
7
8
Figure C-2
Figure C-2
Switch
1 RD+
2 RD-
3 TD+
6 TD-
4 NC
5 NC
7 NC
8 NC
Supported Power Cords and Plugs
A separate power cord is provided for each power supply. Standard power cords or jumper power cords
are available for connection to a power distribution unit having IEC 60320 C13 outlet receptacles. The
jumper power cords, for use in cabinets, are available as an option instead of the standard power cords.

Power Cords

The standard power cords have an IEC C15 connector on the end that plugs into the switch. The optional
jumper power cords have an IEC C15 connector on the end that plugs into the switch, and an IEC C14
connector on the end that plugs into an IEC C13 outlet receptacle.
Only the standard power cords or jumper power cords provided with the switch are supported.
Note
Cisco MDS 9100 Series Hardware Installation Guide
C-4
lists the connector pinouts and signal names for a 10/100BASE-T management port (MDI)
10/100BASE-T Management Port Cable Pinout
Signal
TD+
TD-
RD+
RD–
Not used
Not used
Not used
Not used
shows a schematic of the 10/100BASE-T cable.
Twisted-Pair 10/100BASE-T Cable Schematic
Switch
1 RD+
2 RD-
3 TD+
6 TD-
4 NC
5 NC
7 NC
8 NC
Appendix C Cable and Port Specifications
OL-16187-01