Adding A New Programme; Maintaining Programme - Honeywell Friedland GlobalGuard Operating Manual

2-6-1-1. Adding a new Programme

Click [Add New Programme] when you wish to add a
new Programme to the system. The system will bring
up the Setting – Programme – New Programme
window for you to edit relevant details. For more
information on Programme maintenance, refer to the
section below 2-6-1-2 on "Maintaining Programmes".
Note: For detailed information on assigning a
programme to a Programme Key, which
correspond to a Function Key on the Control Panel,
please refer to page 7.
Example of Programmes could be using Function key I
to activate a group of ON/OFF plug/lampholder devices
ON and Function Key II to turn these OFF if pressed.
Function key III to arm your system and turn ON an
ON/OFF device at the same time, etc.
2-6-1-2. Maintaining Programmes
To maintain an existing Programme, simply click on the
icon of the desired Programme to access the
Programme maintenance screen. You can choose up
to 16 actions to be taken in a single Programme,
including Sound (audio), Step1 (Control Panel security
mode) and Step2 (customized Home Automation
control actions) and so forth. The system will keep tally
on the actions that you have configured and once you
have configured 16 actions for a Programme, the
system will lock the action setting mode and you will
only be able to disable actions but not add new ones
when that happens.
CUSTOMER HELPLINE
Most issues can be solved over the phone in a few minutes.
Please contact our Helpline Team on the number below for any
installation and general advice regarding our products:
0844 736 9149
Lines open 9.00am to 5.00pm, Monday to Friday.
Calls charged at service providers national rate.
The following section will cover relevant Programme
maintenance information:
Name: Programme Name; you may create a name for
the selected Programme for easy identification.
Number: Denotes the number of Programme currently
available on the system; you can have up to a
maximum of 16 Programmes.
Icon: You can change the default icon into any other
icon you prefer (the file extension for the icon must be
in ".ico").
Sound: Enable sound effect playback by the Control
Panel; you can choose 'None' or Chime sound.
Programme: Shows the status of the selected
Programme; click "Enable" to activate the Programme
and "Disable" to deactivate it.
Step1: Configure the type of security mode for the
Control Panel to employ.
1. No Setting: Use the current security mode set
for the Control Panel without making any
change.
2. Fully Arm: the Control Panel will go into "Fully
Arm" security mode.
3. Part-Arm-I: the Control Panel will go into
"Part-Arm-I " security mode. You can check to
see the acting zone detectors under "Intruder
Detector" to find out which zone detectors will be
activated in this security mode.
4. Part-Arm-II: the Control Panel will go into
"Part-Arm-II " security mode. You can check to
see the acting zone detectors under "Intruder
Detector" to find out which zone detectors will be
activated in this security mode.
5. Disarm: the Control Panel will disable security
mode.
6. Holiday Arm: the Control Panel will go into
"Holiday Arm" security mode.
Step2: Configure the type of action for Home
Automation controllers to take.
1. No Action: No action taken on any ON/OFF
home automation receiver device.
2. All On: Home Automation controllers will turn on
all ON/OFF receiver devices that have had their
"All On" option checked under Home Automation
setting.
3. All Off: Home Automation controllers will turn off
all ON/OFF receiver devices.
4. Individual: Home Automation controllers will
perform the action that the user has selected
and customized (Turn On/Off...) for
corresponding ON/OFF receiver devices.
: Click this button and the system will display
where the selected Programme is applicable for your
13