Technical Specifications - AEG 7040 TWF User Manual

Setting
Water hardness
Emptying water
reservoir
2)
warning off
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the
end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity
values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir
is full. When using an external drain for the condensed water warning can be offi

TECHNICAL SPECIFICATIONS

Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Necessary fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-
drained at 1000 rpm)
1. Turn the programme selector to any programme.
1)
2. Press simultaneously the EXTRA DELICATE (EXTRA SANFT) (1) and TIME
(ZEITWAHL) (5) buttons and hold down for approx. 5 seconds. The current
setting is on the display:
–
–
–
3. Press the START PAUSE button (6) sequentially until you set desired level.
4. To memorize setting press simultaneously the EXTRA DELICATE (EXTRA
SANFT) (1) and TIME (ZEITWAHL) (5) buttons or turn knob to OFF (AUS)
position
1. Turn the programme selector to any programme.
2. Press simultaneously the INTENSIVE (TROCKNEN PLUS) (2) and TIME
-
(ZEITWAHL) (5) buttons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
– warning
2)
Implementation
low conductivity <300 μS/cm
medium conductivity 300-600 μS/cm
high conductivity >600 μS/cm
icon and - warning message is off
icon and - warning message is switched on
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 52 kg
1)
max. 7 kg
220-230 V
6 A
1050 W
A
1.85 kWh
Technical specifications
51