Machine Settings - AEG 7040 TWF User Manual

50

Machine settings

5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be ob-
tained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the appliance!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
MACHINE SETTINGS
Setting
Buzzer perma-
nent on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the EXTRA DELICATE (EXTRA SANFT) (1) and INTEN-
SIVE (TROCKNEN PLUS) (2) buttons and hold down for approx. 5 seconds.
– diode above BUZZER (SIGNAL) button (4) starts lighting - buzzer per-
manently on.
– lighting diode comes off - buzzer permanently off.
3. The buzzer is by default always off. You can use the BUZZER (SIGNAL)
button (4) to activate or deactivate sound but the machine does not
memorize your selection.
Implementation