Refer to the following diagrams to do the settings.
The trim angle changes in the directions shown by the arrows.
Leftward orientation
setting value
3
Adjust the cutting angle in reference to the center of the edge.
For example, if you input 0.2" (6 mm) to adjust the trim angle, the cutting angle is adjusted
based on the position of the center of the edge by half of the input value; 0.1" (3 mm) in
this case.
Trim angle input
3-16
Adjustments from the Printer Display
Increase
Decrease
setting value
0.2" (6 mm)
Rightward orientation
Increase
setting value
<Top>
<Bottom>
<Foredge>
Result of adjustment
0.1"
(3 mm)
The
shows the center position (center of
the edge) of the cutting angle.
Decrease
setting value
0.1"
(3 mm)