Advertisement
2
ATW Wireless System
Route the cable out the back of
the control and electrical box,
and run the cable into the box
through the shown inlet in the
underside of the box.
Connect the cable connector to
the CNRF terminal on the control
board. Switch ON SW1-8.
Remove excessive slack on the
cable , then secure the cable
with a cable fastener and 2 ca-
ble straps on the upper side and
center on the back of control and
electrical box.
Place the control and electrical box back in the original position and reinstall the 3 screws.
Control and
Control board
electrical box
Back view
Cable
fastener
Cable
straps
Optional parts
SW1
Control and
electrical box
CNRF
Control and
electrical box
D-15
Advertisement
