Specifications - Makita JR1000FT Instruction Manual

ENGLISH (Original instructions)
1-1. Clamping screw
1-2. Cover
1-3. Shoe
2-1. Hex wrench
3-1. Shoe
4-1. Switch lever

SPECIFICATIONS

Length of stroke
Max. cutting capacities
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for sawing wood, plastic, metal and
building materials with a strong impact. It is suitable for
straight and curved cutting.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : cutting boards
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting wooden beams
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Explanation of general view
5-1. Speed adjusting dial
5-2. Lower
5-3. Higher
6-1. Lamp
7-1. Holder cover
7-2. Blade clamp
Model
Pipe
Wood
-1
)
Overall length
Net weight
Safety class
) : 78 dB(A)
pA
value (tri-axial vector
2
) : 21.0 m/s
h,B
2
2
) : 16.5 m/s
h,WB
2
ENE021-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF002-2
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG900-1
EC Declaration of Conformity
We Makita
sum)
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Recipro Saw
Model No./ Type: JR1000FT
are of series production and
Conforms to the following European Directives:
2006/42/EC
3
7-3. Fixed position
7-4. Released position
8-1. Saw blade
8-2. Blade clamp
11-1. Front holding area
11-2. Collar
JR1000FT
14 mm
25.4 mm
55 mm
0 - 4,800
345 mm
1.6 kg
/II
Corporation as the
ENG901-1
ENH101-16
responsible