Operation - Makita TD0101 Instruction Manual

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing driver bit or
socket bit
► Fig.4
Use only bits that has inserting portion shown in the
figure.
For European and North & South
American countries, Australia and
New Zealand
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
For other countries
To install these types of bits, follow
A=17mm
the procedure (1).
B=14mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
► Fig.5: 1. Bit 2. Sleeve
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
► Fig.6: 1. Bit 2. Bit-piece 3. Sleeve
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.

OPERATION

► Fig.7
NOTE:
• The size of wood screw which can be fastened
with this tool may differ depending upon the type
of material to be fastened. Always perform a test
operation to determine the size of wood screw.
Holding the tool
Hold the tool only by the handle when performing an
operation. Do not touch the metal part.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
.
N m
(kgf.cm)
120
(1224)
100
(1020)
80
(816)
60
(612)
40
(408)
20
(204)
0
.
N m
(kgf.cm)
100
(1020)
80
(816)
60
(612)
40
(408)
20
(204)
0
6 ENGLISH
Standard bolt
M14
M12
M14
M10
M12
M10
M8
M8
3.0
2.0
1.0
(S)
Fastening time
High tensile bolt
M8
2.0
1.0
Fastening time (S)
M10
M10
M8
3.0