Philips VisaCare SC6240 Manual page 15

Home microdermabrasion, skin resurfacing treatment
Hide thumbs Also See for VisaCare SC6240:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Problem
It is difficult to slide the
appliance over my skin/I
do not feel the suction/
the effect seems to be
less than after previous
treatments.
I have trouble keeping
the suction on my
forehead.
I do not know when to
start using the 'Normal'
treatment tip.
Solution
Check if the filter is clogged. Clean the treatment tip by rinsing it under the
tap. If the exfoliation ring is dirty, let the tip soak in hot water with washing-up
liquid for 5-10 minutes. You can use the cleaning brush to clean it. Make sure
you clean the filter with the treatment tip upside down to rinse off any dirt
left in the filter. Dry the treatment tip with a lint-free towel or let it air-dry.
Check if you can feel the suction of the appliance when the treatment tip is
taken off: you remove the tip and then switch on the appliance. When you
put your finger on the hole, you should be able to feel the suction. If you
do not feel the suction, the appliance might be broken. Please contact your
Philips Consumer Care Centre.
Try different ways of holding the appliance in order to find the right angle
of the treatment tip with the forehead for good skin contact. Make sure to
move the appliance slowly over the forehead. You can try to hold your hand
still and move your head instead.
As soon as you do not experience side effects from using the 'Sensitive'
treatment tip, you may try the 'Normal' treatment tip. Please note that the
first time you use a new treatment tip, you may have a different skin reaction.
Give your skin some time to get used to the new tip.
ENGLISH
15

Advertisement

Table of Contents
loading

Table of Contents