Table of Contents
Advertisement
Steps
1. Slide the ethernet and audio board into the M.2 card slot on the system board.
2. Align the screw holes on the ethernet and audio board to the screw holes on the system board.
3. Replace the two screws (M2x4) that secure the ethernet and audio board to the system board.
4. Turn the system-board assembly over.
Next steps
1. Install the
system
board.
2. Install the
wireless
card.
3. Install the
solid-state
4. Install the
rear
cover.
5. Install the battery.
6. Install the
base
cover.
7. Follow the procedure in
Power button
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state
6. Remove the
wireless
card.
7. Remove the
system
board.
NOTE:
The system board can be removed as an assembly with the memory modules, fan and heat-sink assembly,
ethernet and audio board, and USB board attached.
drive.
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing components
55
Advertisement
Table of Contents
