Installing The Fan And Heat-Sink Assembly (Nvidia Geforce Rtx 3060/3070/3070 Ti Graphics Card) - Dell G16 7620 Service Manual

Steps
1. Turn the system-board assembly over.
2. In sequential order (1>2>3>4>5>6), remove the six screws (M2x4) that secure the fan and heat-sink assembly to the
system-board assembly.
3. Lift the fan and heat-sink assembly off the system-board assembly.
Installing the fan and heat-sink assembly (NVIDIA GeForce RTX
3060/3070/3070 Ti graphics card)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: This procedure only applies to computers shipped with a NVIDIA GeForce 3060/3070/3070 Ti graphics card.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the
installation procedure.
NOTE: If either the system board or the heat sink is replaced, use the thermal pad that is provided in the kit to ensure that
thermal conductivity is achieved.
48 Removing and installing components