Disk Access Led ( ); Optical Disk Access Led; Link/Act Led ( 1, 2, M); Speed Led ( 1, 2, M) - NEC Express5800/GT110e EXP280A User Manual

Chapter 1 General Description
4.5.3
Disk Access LED (
Disk Access LED lights or flashes green when an internal hard disk drive or the optical disk drive is being
accessed.
When RAID System using an optional RAID Controller is configured, this LED lights amber if hard disk drive
error occurs. It lights amber and green alternately if the failed hard disk drive is being rebuilt.
4.5.4

Optical Disk Access LED

The LED lights/flashes when the media set on the optical disk drive is being accessed.
4.5.5
LINK/ACT LED ( 1,
This LED indicates the state of the standard LAN port. If the server and HUB is supplied with power and
connected properly, the LED is on (LINK). If the LAN port is transmitting/receiving data, the LED flashes
(ACT).
If the LED does not turn on in LINK state, check the cable or connection.
4.5.6
SPEED LED ( 1,
This LED indicates which network interface is used.
− The two LAN ports for data transmission support 1000BASE-T, 100BASE-TX, and 10BASE-T and the
LED indicates which network interface is being used.
• Amber: Operating with 1000BASE-T
• Green: Operating with 100BASE-TX
• OFF:
− Management LAN port supports 100BASE-TX and the LED lights green during the operation.
)
Tips
When RAID Controller (N8103-149/150/151) is used, Disk Access LED lights
amber immediately after the server is powered on or reset, however, it is not a
failure.
2, M)
2, M)
Operating with 10BASE-T
Express5800/GT110e User's Guide
4. Names and Functions of Parts
39