Cisco 30 VIP Troubleshooting Manual page 82

For cisco callmanager release 3.0(1)
Hide thumbs Also See for 30 VIP:
Table of Contents

Advertisement

Cisco IP Telephony Troubleshooting Guide for Cisco CallManager Release 3.0(1)
Field Definitions
originalCallingPartyNumberPartition
origCause_Location
origCause_Value
origMediaTransportAddress_IP
origMediaTransportAddress_Port
origMediaCap_payloadCapability
origMediaCap_maxFramesPerPacket
origMediaCap_g723BitRate
lastRedirectDn
lastRedirectDnPartition
destLegIdentifier
© 2000 Cisco Systems, Inc.
Calling party's partition
up to 50 characters
This field contains the Partition associated with the calling
party.
ISDN location value
unsigned integer
This field contains the location value from the Cause
information Element.
Calling party cause Of call termination
unsigned integer
This cause represents why the call to the originating device
was terminated. In the case of transfers, forwards, and so on,
the cause of call termination may be different for the
originating device and the termination device. Thus, there are
two cause fields associated with each call. Usually they will
be the same.
The IP address for the originator's media connection
unsigned integer
This is the destination IP Address to which the Media Stream
from the originator was connected.
The port for the originator's media connection
unsigned integer
This is the destination port to which the Media Stream from
the originator was connected.
The codec type used by the originator
unsigned integer
This field contains the Codec type (compression or payload
type) that the originator used on the sending side during this
call. It may be different than the codec type used on its
receiving side.
The number of milliseconds of data per packet
unsigned integer
This field contains the number of milliseconds of data per
packet sent to the destination, by the originator of this call.
The actual data size depends on the codec type being used
to generate the data.
The bit rate to be used by G.723
unsigned integer
Defines the bit rate to be used by G.723. There are two bit
rate values. They are: 1 =5.3K bit rate, and 2 = 6.3K bit rate.
Directory number of the party that last redirected this call
up to 25 characters
This is the directory number of the last device that redirected
this call. This field applies only to calls that were redirected,
such as conference calls, call forwarded calls, and so on.
Partition of the phone that last redirected this call
up to 50 characters
This is the Partition of the last device that redirected this call.
This field applies only to calls that were redirected such as
conference calls, call forwarded calls, and so on.
The call identifier for the destination leg of the call
unsigned integer
This is a unique identifier that is used to track the destination
leg of this call. It is unique within a cluster.
82

Advertisement

Table of Contents
loading

This manual is also suitable for:

30

Table of Contents