3.3.15
APM Configuration
ErP Ready
Allows you to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled]
Restore AC Power Loss
[S5 State]
The system goes into off state after an AC power loss.
[S0 State]
The system goes into on state after an AC power loss.
Power On By PCIE/PCI
This item allows you to enable or disable the Wake-on-LAN function of the onboard
LAN controller or other installed PCIe/PCI LAN cards. Configuration options:
[Disabled] [Enabled]
Power On By PS2
Enables or disables the system to be powered on by a PS/2 keyboard or mouse.
Configuration options: [Disabled] [Enabled]
Power On By Ring
[Enabled]
Enables the Ring devices to generate a wake event.
[Disabled]
Disables the Ring devices to generate a wake event.
Power On By RTC
[Disabled]
Disables RTC to generate a wake event.
[Single event] Allows you to generate a single wake event.
[Daily event]
Allows you to generate a daily wake event.
[Weekly event] Allows you to generate a weekly wake event.
[Monthly event] Allows you to generate a monthly wake event.
3.3.16
EzFlash
Enter Ez-Flash mode
This item allows you to run EzFlash utility. When you press <Enter>, a confirmation
message appears. Use the left/right arrow key to select between [Yes] or [No],
then press <Enter> to confirm your choice.
3.3.17
Watchdog Timer
Watchdog Support
This item allows you to enable or disable Watchdog timer. Configuration options:
[Enabled] [Disabled]
The following items appear when you set Watchdog Support to [Enabled].
Chapter 3: BIOS setup
3-13