Table of Contents
Advertisement
data, if the receiving buffers are full, a "stop" signal can be sent to stop the
data flow. Once the buffers are empty, a "start" signal can be sent to re-start
the flow. Hardware flow control uses two wires to send start/stop signals.
Configuration options: [None] [Hardware RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/
VT100 terminals. Configuration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal
data. Configuration options: [Disabled] [Enabled]
Resolution 100x31
Allows you to enable or disable extended terminal resolution.
Configuration options: [Disabled] [Enabled]
Putty KeyPad
Allows you to select FunctionKey and KeyPad on Putty.
Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
3.3.9
SATA Configuration
This item allows you to configure SATA device options settings.
SATA Controller(s)
Allows you to enables or disables the onboard SATA device.
Configuration options: [Disabled] [Enabled]
The following item appears only when you set SATA Controller(s) to [Enabled].
SATA Mode Selection
Allows you to determine how SATA controller(s) operate. Configuration options:
[AHCI]
[AHCI]
Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard
storage driver to enable advanced Serial ATA features that increases
storage performance on random workloads by allowing the drive to
internally optimize the order of commands.
SATA6G_1/2/3/4
Allow you to enable/disable the SATA6G_1/2/3/4 port. Configuration options:
[Disabled] [Enabled]
Hot Plug
Allow you to enable/disable the hot plug function. Configuration options: [Disabled]
[Enabled]
3-10
H610A-IM-A
Advertisement
Table of Contents
