Advertisement
Reset Button
Press the Reset button continuously for 5 sec. to load factory defaults: Use a pointed object, such as a
straightened paper clip or toothpick, to press the reset button. This will cause the Ready LED to blink on
and off. The factory defaults will be loaded once the Ready LED stops blinking (after about 5 seconds)
At this point, you should release the reset button.
Factory default settings include an active password protection. The factory default password is "moxa".
LED Indicators
The Ethernet converter has three LED indicators, which are described in the following table.
LED Name
Ready
Link
Tx/Rx
--------------------------------------------------------------------------------3/6--------------------------------------------------------------------------------
LED Color
LED Function
Red
Steady on: Power is on and Ethernet converter is booting up.
Blinking: Indicates an IP conflict, or DHCP or BOOTP server
is not responding proberly.
Steady on: Power is on and Ethernet converter functioning
Green
normally.
Blinking: The Ethernet converter has been located by Admin-
istrator´s Location function.
Off
Power is off, or power error condition exists.
Orange
10 Mbps Ethernet connction.
Green
100 Mbps Ethernet connction.
Off
Ethernet cable is disconnected, or has a short.
Orange
Serial port is receiving data.
Green
Serial port is transmitting data.
Off
No data is being transmitted or received though the serial port
Advertisement
