Reviewing An Image Right After Shooting - Canon PowerShot S80 User Guide Basic User Manual

01_EC176Basic_E.fm Page 9 Tuesday, June 28, 2005 10:06 AM
For settings that can be changed in this mode (the Advanced Guide:
p. 160).
Images are first saved into the camera's internal memory before being
recorded onto the memory card, allowing the next images to be taken
immediately as long as sufficient space is available in the internal
memory.
The upper indicator blinks green while data is recorded onto the memory
card.
The beep and shutter sound can be set to On/Off using the [Set up] menu
(the Advanced Guide: p. 29).
Shots cannot be taken while the flash is charging (the white
blinks when pressing the shutter button halfway while the flash is
charging, and it stops blinking when shooting is enabled).
You can change the length of time images show on the LCD monitor
after shooting, or set it so they do not show at all (the Advanced Guide:
p. 21).

Reviewing an Image Right After Shooting

After a shot is taken, the image appears in the LCD monitor for
approximately 2 seconds.
To Continue to Display Images
Keeping the shutter button pressed after a shot.
Pressing the FUNC./SET button while the image is displayed in the LCD
monitor.*
* This operation is not available in Stitch Assist mode (the Basic Guide: p. 10).
You can perform the following while an image is displayed (stitch assist is
not available).
Display the image's information (the Advanced Guide: p. 18).
Display the magnified image (the Advanced Guide: p. 88).
Erase individual images (the Basic Guide: p. 15).
Attach sound memos (the Advanced Guide: p. 97).
See the Advanced Guide: Changing the Review Duration (p. 21).
mark
9