Replacing The Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb; Replacing The License Plate Light Bulb - Yamaha Xmax 250 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing the tail/brake light
bulb or a rear turn signal
light bulb
Tail/brake light bulb
6
1. Remove the tail/brake light bulb
lens by removing the screws.
2. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
EAUS1250 Rear turn signal light bulb
1. Remove the tail/brake light lens
by removing the screw.
2. Remove the turn signal light bulb
lens by removing the screw.
3. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
5. Install the turn signal light bulb
lens by installing the screw.
6. Install the tail/brake light bulb
lens by installing the screw.
CAUTION:
Do not overtighten the screws,
otherwise the lens may break.
Replacing the license plate
light bulb
1. Remove the lens by removing the
2. Remove the defective bulb by
3. Insert a new bulb into the socket.
4. Install the lens by installing the
CAUTION:
Do not overtighten the screw,
otherwise the lens may break.
ECA10680
6-27
screw.
pulling it out.
screw.
EAUS1150
ECA11190