Final Transmission Oil - Yamaha Xmax 250 Owner's Manual

Recommended engine oil:
See page 8-1.
Oil change quantity:
1.2 L (1.27 US qt) (1.05 Imp.qt)
CAUTION:
Do not use oils with a diesel
specification of "CD" or oils of
a higher quality than specified.
In addition, do not use oils
labeled "ENERGY CONSER-
VING II" or higher.
Be sure no foreign material
enters the crankcase.
7. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the cau-
se.
8. Reset the oil change indicator.
(See page 3-8.)
PERIODIC MAINTENANCE AND MINOR REPAIR

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
ECA11670
scooter. In addition, the final trans-
mission oil must be changed as
follows at the intervals specified in the
periodic maintenance and lubrication
chart.
1. Start the engine, warm up the
final transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2. Place the scooter on the centers-
tand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
EAU20061
1. Final transmission oil filler cap
4. Remove the oil filler cap and
1. Final transmission oil drain bolt
5. Install the final transmission oil
6-10
1
drain bolt to drain the oil from the
final transmission case.
1
drain bolt, and then tighten it to
the specified torque.
6