Tailstock - Grizzly G4003 Manual Insert

If the stock is thinner at the tailstock end, the
tailstock needs to be moved away from the
operator by at least the amount of the
taper. See Figure 31.
Figure 31. Adjusting for tailstock end taper.
7. Loosen the tailstock mounting bolt. Adjust
the tailstock offset by the amount of the
taper by turning the adjustment setscrews.
See Figure 32. Turn another .010'' off of
the stock and check for taper. Repeat as
necessary until the desired amount of accu-
racy is achieved.
-26-
NOTICE
Do Not forget to lock down the tailstock after
each adjustment.
Adjustment Screw
Figure 32. Tailstock offset adjustment screw.
G4002/3 Gear Head Lathes
Lock Screw