Finishing Mode; Electronic Function - Makita DPO600 Instruction Manual

Random orbit mode is orbital action with free rotation of
the pad for fine polishing.
Rotate the change knob clockwise for random orbit mode.

Finishing mode

In the finishing mode, you can operate the tool without applying
excessive load. This mode is suitable for finishing operation.
To use the tool in the finishing mode, pull the switch trigger and
release it to turn on the tool, and then press the mode switching
button. The lamp lights up in green. To return to the normal mode,
press the mode switching button while the tool is turned on.
► 1. Lamp 2. Mode switching button
NOTE: You cannot change the mode when the tool
is running.
Accidental restart preventive function
If you install the battery cartridge while pulling the switch trigger
or locking the switch trigger, the tool does not start. To start the
tool, release the switch trigger, and then pull the switch trigger.

Electronic function

The tools equipped with electronic function are easy to
operate because of the following features.
Constant speed control
Possible to get fine finish, because the rotating speed is
kept constant even under the loaded condition.
Soft start feature
Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing the backing pad
1
2
► 1. Hex wrench 2. Bolt 3. Backing pad
Put the backing pad on the shaft then turn the bolt
clockwise with a hex wrench.
secured properly. Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
Installing side grip
Optional accessory
Otherwise, the front cover may fall and cause an injury.
► 1. Cap 2. Side grip
8 ENGLISH
1
2
3
CAUTION:
Make sure that the backing pad is
CAUTION:
Tighten the caps or side grip firmly.
1
2