Makita CS01 Instruction Manual page 8

Guide scale
Use the guide scale if you wish to cut threaded rods in
the same length. Insert the guide scale into the hole as
shown in the figure.
2
► 1. Guide scale 2. Clamping screw
Align the value of your desired length on the guide scale
with the cutting line. Then tighten the clamping screw.
2
► 1. Guide scale 2. Cutting line 3. Clamping screw
CAUTION:
Do not hold the guide scale to
carry or handle the tool. The tool may fall off and
cause personal injury and/or damage to the tool.
Rod guide
For a precise cutting, set the rod guide in position
depending on the diameter of the threaded rod to be
cut.
► 1. Rod guide (Position 1) 2. Rod guide (Position 2)
1
1
There are two rod guide positions.
Position
1
2
Hook
1
CAUTION:
location or a potentially unstable surface.
CAUTION:
deformed or damaged.
CAUTION:
always fold the hook.
The hook is convenient for hanging the tool temporarily.
3
► 1. Hook
CAUTION:
waist belt. It may result in personal injuries and/or
damage to the tool if dropped.
2
8 ENGLISH
Size of threaded rod
W3/8, 3/8-16UNC, M10
W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,
M8, M6
Never hook the tool on a windy
Do not use the hook when it is
When not operating the tool,
1
Do not hang the hook from the