Advertisement
Installing the Booster with the
Optional Power Injector
Note: As noted in the illustration below, be sure to disconnect the DC power adapter from the
ANT24BNA Booster for 802.11b, and connect it to the NETGEAR ANT24BDC Power Injector.
Antenna
e. g. NETGEAR
ANT24O5
Injector NETGEAR
ANT24BDC
Do NOT connect
DC cable
Connect
Antenna
cable
500 mW Booster ANT24BNA
Connect
NETGEAR
Antenna
Antenna
cable
cable (short)
6
Current antenna
Do NOT remove
Wireless unit
Connect
ETHERNET
5-12V DC
Antenna
RESET
cable
NETGEAR
Primary
Secondary
Antenna cable
(short or medium)
Connect
Antenna
cable
Connect
DC cable
DC Block NETGEAR
Connect
Antenna
cable
NETGEAR Antenna
cable (medium or long)
Specifications
NETGEAR 500mW Bi-directional
Description
Booster for 802.11b, with Two
Female Reverse SMA Connectors
Frequency Range
2400 to 2500 MHz
Operating Mode
TDD Burst Mode
DC Surge Protection
600 Watts TVS @ 6VDC
Current Drain (TDD Mode)
700 mA type. @ 6VDC
Transmit Power
26.5 dBm minimum
Transmit Input Power
+ 5 dBm minimum
Transmit Ramp Up Time
3 µs maximum
10 dB typical
Receiver Gain
Receiver Frequency Response
±1 dB over operating range
Receiver Noise Figure
5 dB maximum
Receiver Ramp Down Time
3 µs maximum
Material
ABS
Color
White
Device Size (l x w x h)
130 x 75 x 37 mm (5.1 x 3.0 x 1.5 in)
Weight
5.0 g/1.1 lbs (including DC adapter)
SMA female reverse (2x), 1 for connection to antenna,
RF Connector Type
1 for connection to ME103 wireless access point
RF Connector Impedance
50 ± 5 Ohms
RF Connector Dielectric
750 VRMS maximum
Withstanding Voltage
RF Connector Insertion Loss
0.2 dB
7
Advertisement
