Page 2
Introduction This section introduces the NETGEAR ANT24BNA 500 mW Bi-directional Booster and the NETGEAR ANT24BDC 6 VDC, 1.5A Power Injector and related components. The 500-milliwatt bi-directional power booster for the NETGEAR ME103 802.11b ProSafe Wireless Access Point increases the transmission signal from an average 50 mW to 500 mW and amplifies the signal by 10 dB (10 times) in receive mode.
Page 3
Power Injector Package Contents – Use a NETGEAR antenna cable of no more than 3 m between the Power Injector and the access point. – For optimal performance, the combined length of both NETGEAR antenna cables should not exceed 13 m. If the length exceeds 13 m, the overall performance will decrease.
Note: As noted in the illustration below, be sure to disconnect the DC power adapter from the Female Reverse SMA Connectors ANT24BNA Booster for 802.11b, and connect it to the NETGEAR ANT24BDC Power Injector. Frequency Range 2400 to 2500 MHz...
NETGEAR 500mW Bi-directional NETGEAR PWR-10015-01 DC Description Booster for 802.11b, with Two Description Adapter Specifications Female Reverse SMA Connectors AC Input Voltage 90 to 264 V RF Connector Recommended 0.45 to 0.99 Nm (4.0 to 8.8 in.lb.) Coupling Nut Torque...
Page 7
Specifications ANT24BDC Power Injector for the Description ANT24BNA Booster with Two ANT24BDC Power Injector for the Female Reverse SMA Connectors Description ANT24BNA Booster with Two Female Reverse SMA Connectors Operation Temperature 0 to 70° C (32 to 158° F) Storage Temperature -10 to 80°...
In the internal function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.